trany swap
2 posters
Page 1 of 1
trany swap
i am putting an a-833 4spd in my duster it is a short shaft model it was originally behind a 225 slant six. my question is what will i need to make this transmission workbehind a 360 sb., the car was a manual 3 speed on the floor with a 225 slant motor under the hood. i have already swapped the front k member for the v-8 conversion at that time it also got power front disk brakes and power steering( all swapped parts came from a doner car) any helpful advice would b greatly appericated
'70 sublime duster-
Number of posts : 2
Registration date : 2011-03-19
Re: trany swap
You need the proper 360 flywheel other than that you want need anything special. You can't use the 6 cyl Z bar on hte clutch linkage, you have to have one for a V8 it's about 3/4 inch shorter on the arm that is near the clutch fork.
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|